5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 269 of 356 (
D99875607-91
)
5.27.3
Re-install
To re-install the tipper heater, reverse the removal steps:
1)
Orient the tipper heater with the flat side down and the cables coming off to the right (
),
and insert it into the tipper, resting on the ramp.
2)
Route the cable out the front of the tipper.
3)
Use the 1/8” L-handle hex wrench to push down on the
right
spring-loaded post, line it up with the
screw hole in the heater, and tighten it only enough to hold the heater up.
Figure 5-125 - Hand-tightening the First Spring-loaded Post (TOP VIEW)
4)
Install the
left
spring-loaded post the same way.
5)
Tighten both loaded posts.
6)
Re-insert the tipper sensor into its slot and hold it in place. Route the sensor cable out the front,
alongside the heater cable.