5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 104 of 356 (
D99875607-91
)
5.6.3
Re-install
To re-install the latch, follow these steps:
1)
Support the latch and re-fasten it to the case using the three screws and lock washers.
2)
Connect the solenoid cable.
3)
Clip the cable into the three cable clips in the front right corner of the case. The installation should
look like the pictures below.
4)
Trace the connected cable to below the hopper plate. Pull gently downward on the cable to take up
the slack from above, then tuck the cable below the other cables below the hopper plate as shown.
