262391
60
Revision A
1033176
A
B
Figure 3.53: Conditioner Drive
9.
Determine center point (A) between the two marks on the
yoke plate, and place a third mark.
10. Rotate upper roll (B) counterclockwise until the mark on
the gearbox flange lines up with the third (center) mark.
1018518
A
Figure 3.54: Conditioner Drive
11. Ensure that the threads on four bolts (A) are clean and free
of lubricant.
NOTE:
Only three of the four bolts are shown in the illustration.
12. Apply medium-strength threadlocker (Loctite
®
242 or
equivalent) to bolts (A), and tighten them. Torque the bolts
to 95 Nm (70 lbf·ft).
3.14.4
Forming Shields
–
Roll Conditioner
The forming shield position controls the width and placement of the windrow.
Consider the following factors when setting the forming shield position:
•
Weather conditions (rain, sun, humidity, and wind)
•
Type and yield of crop
•
Available drying time
•
Method of processing (bales, silage, and green-feed)
