262391
93
Revision A
1022896
A
A
Figure 4.26: Spirit Level on Cutterbar
7.
Use spirit level (A) to ensure that the cutterbar is level in
both directions. Adjust the cutterbar position accordingly.
1004033
A
B
Figure 4.27: Cutterbar Oil Inspection Plug
8.
Clean the area around plug (A). Place a 5 liter (5.2 US qts)
capacity container under the plug.
9.
Remove plug (A) and O-ring (B) from the cutterbar. The oil
level must be up to the inspection plug hole.
NOTE:
If additional lubricant is required, proceed to Step
. If additional lubricant is
NOT
required, proceed to
Step
.
IMPORTANT:
Do
NOT
overfill the cutterbar. Overfilling can cause
overheating, damage, and failure of the cutterbar
components.
10. Reinstall the inspection plug.
11. Start the engine, and raise the header slightly.
12. Lower the header onto blocks, so that the left end is slightly higher than the right end.
13. Shut down the engine, and remove the key from the ignition.
14. Add lubricant through the inspection hole used to check the oil level.
IMPORTANT:
Do
NOT
overfill the cutterbar. Overfilling can cause overheating, damage, and failure of cutterbar components.
NOTE:
Refer to the inside back cover of this manual for lubricant specifications.
