262391
91
Revision A
Installing Outboard Curtains
The procedure for installing outboard curtains is the same for both sides of the machine.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. If the rotary disc
header is raised, always close the lock-out valves, and place blocks under the header. Never work on or beneath an
unsupported header.
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Disc blades have two sharp cutting edges that can cause serious injury. Exercise caution and wear gloves when working
with, or near, blades.
1.
Position the rotary disc header at an appropriate height for the task.
2.
Shut down the engine, and remove the key from the ignition.
3.
If the rotary disc header is raised:
a.
Place blocks under each end, or just inside each end, of the cutterbar.
b.
Lower the rotary disc header onto the blocks.
c.
Shut down the engine, and remove the key from the ignition.
d.
Close the auxiliary lift cylinder lock-out valves. For instructions, refer to
3.2.1 Locking and Unlocking Auxiliary Lift
.
4.
Open the cutterbar doors. For instructions, refer to
3.4.1 Opening Cutterbar Doors, page 26
1021000
D
B
A
C
Figure 4.24: Outboard Curtain
5.
Install curtain (A) into bracket (B).
NOTE:
R1 SP for windrowers shown in the illustration; R1 FR
similar.
6.
Install two nuts (D) and tighten them.
7.
Slide bracket (B) into position and install square neck
carriage head bolt and flange nut (C).
8.
Torque flange nut (C) to 39 Nm (29 lbf·ft).
