262391
90
Revision A
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Disc blades have two sharp cutting edges that can cause serious injury. Exercise caution and wear gloves when working
with, or near, blades.
1.
Position the rotary disc header at an appropriate height for the task.
2.
Shut down the engine, and remove the key from the ignition.
3.
If the rotary disc header is raised:
a.
Place blocks under each end, or just inside each end, of the cutterbar.
b.
Lower the rotary disc header onto the blocks.
c.
Shut down the engine, and remove the key from the ignition.
d.
Close the auxiliary lift cylinder lock-out valves. For instructions, refer to
3.2.1 Locking and Unlocking Auxiliary Lift
.
4.
Open the cutterbar doors. For instructions, refer to
3.4.1 Opening Cutterbar Doors, page 26
1020992
A
B
Figure 4.22: Left Endsheet
5.
Remove four bolts, large washers, and nuts (A) securing
outboard curtain (B) to the endsheet.
NOTE:
R1 SP for windrowers shown in the illustration; R1 FR
similar.
1020993
A
C
D
B
Figure 4.23: Outboard Curtain
6.
Remove two nuts (A) from the bolt studs.
NOTE:
R1 SP for windrowers shown in the illustration; R1 FR
similar.
7.
Remove nut (B) from the carriage head bolt, remove
bracket (C), and remove curtain (D).
