262391
100
Revision A
1011304
A
A
B
Figure 4.35: Cutterbar Disc Bolts
5.
Place a pin (or equivalent) in front hole (B) of the rock
guard to prevent the discs from rotating while you are
loosening the bolts.
6.
Remove four M12 bolts and washers (A).
1004039
A
B
Figure 4.36: Cutterbar Disc and Cap
7.
Remove cutterbar disc cap (A).
8.
Remove cutterbar disc (B).
Installing Cutterbar Discs
Ensure that the blades of the installed disc are perpendicular to those on the adjacent discs.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. If the rotary disc
header is raised, always close the lock-out valves, and place blocks under the header. Never work on or beneath an
unsupported header.
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Position the rotary disc header at an appropriate height for the task.
2.
Shut down the engine, and remove the key from the ignition.
