262391
95
Revision A
1024942
A
B
Figure 4.29: Front View of Header on Blocks
7.
Place a 10 liter (10.5 US qts) capacity container under the
lower end of the cutterbar. Clean the area around plug (A)
and remove the plug.
IMPORTANT:
Do
NOT
remove hex head bolts (B) securing the cutterbar
end plate to the cutterbar, or lubricant leaks may result.
NOTE:
R1 SP for windrowers shown in the illustration; R1 FR
similar.
8.
Allow sufficient time for the lubricant to drain. Reinstall
cutterbar plug (A) when the lubricant has been fully
drained.
NOTE:
Do
NOT
flush the cutterbar.
9.
Fill the cutterbar with lubricant before operating the rotary disc header. For instructions, refer to
.
IMPORTANT:
Dispose of used lubricant responsibly.
10. Reinstall the right outboard rock guard. For instructions, refer to
Installing Outboard Rock Guards, page 137
.
Filling Cutterbar with Lubricant
This procedure should be used when the cutterbar has been completely drained of oil.
If you are checking the oil level or topping it up. Proceed to
.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. If the rotary disc
header is raised, always close the lock-out valves, and place blocks under the header. Never work on or beneath an
unsupported header.
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
