262391
142
Revision A
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Position the rotary disc header at an appropriate height for the task.
2.
Shut down the engine, and remove the key from the ignition.
3.
If the rotary disc header is raised:
a.
Place blocks under each end, or just inside each end, of the cutterbar.
b.
Lower the rotary disc header onto the blocks.
c.
Shut down the engine, and remove the key from the ignition.
d.
Close the auxiliary lift cylinder lock-out valves. For instructions, refer to
3.2.1 Locking and Unlocking Auxiliary Lift
.
4.
Open the cutterbar doors. For instructions, refer to
Opening Cutterbar Doors, page 26
1024929
A
B
A
A
A
Figure 4.108: Driveline Shield
5.
Remove four M10 hex flange head bolts (A) and remove
vertical driveshield (B).
1024659
A
B
B
Figure 4.109: Driveline Shield
6.
Remove two M10 hex flange head bolts (B) and cover
plate (A).
