262391
191
Revision A
Checking and Adding Lubricant
–
Header Drive Gearbox
The header drive gearbox will need lubricant checks according to the Maintenance Schedule. Follow this procedure for
checking and added lubricant.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat.
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Park the machine on a flat, level surface.
2.
Lower the header fully.
3.
Adjust the header so gearbox is level to ensure accurate oil level readings.
4.
Shut down the engine, and remove the key from the ignition.
5.
Open the cutterbar doors. For instructions, refer to
3.4.1 Opening Cutterbar Doors, page 26
ϭϬϰϯϴϭϵ
A
Figure 4.203: Drive Gearbox
–
Viewed from Below
6.
Clean around check plug (A) on the forward facing side of
the gearbox.
7.
Remove (lower) check plug (A). Lubricant should be level
with or slightly dripping from the check port.
8.
Install check plug and tighten. If lubricant level is low,
proceed to the next step.
