MacDon M205 2012, Operator'S Manual, Page: 69 / 230

WINDROWER OPERATION
169469/169470/169471
67
Revision E
NOTE
Fill fuel tank daily, preferably at the end of
the day's operation to help prevent
condensation in the tank. Tank Capacity is
97 U.S. Gallons (378 L).
IMPORTANT
Do not fill tank completely; space is required
for expansion. A filled tank could overflow if
exposed to a rise in temperature, such as
direct sunlight.
IMPORTANT
Do not allow tank to empty. Running out of
fuel can cause air locks and/or
contamination of the fuel system. Refer to
Section 7.8.6 Fuel System for priming
procedures.
6.3.5.6 Engine Temperature
The normal engine operating temperature range is
180–225 °F (82 –107 °C), and is indicated by a
gauge on the Operator’s console. If the
temperature exceeds 230 °F (110 °C), an ongoing
intermittent tone will be heard, and the Cab
Display Module (CDM) will flash “ENGINE TEMP”.
Stop the engine immediately, and determine
cause. The tone will stop, and the CDM will return
to normal when the temperature drops below
225 °F (107 °C).
6.3.5.7 Engine Oil Pressure
The nominal engine oil pressure is 10 psi (69 kPa)
at low idle, and 55.1 psi (380 kPa) at maximum
rated speed. If the oil pressure drops below 7.5 psi
(52 kPa), a continuous loud tone will sound and
the CDM display will flash “ENGINE OIL PRESS”.
Shut down the engine immediately if warning
occurs while operating, or if it continues for more
than a few seconds after engine startup.
6.3.5.8 Electrical
IGNITION ENGINE READING
INDICATED
CONDITION
On
Running
13.8–15.0 Normal
> 16.0
See Note
Regulator Out of
Adjustment.
<12.5
See Note
Alternator Not
Working or
Regulator Out of
Adjustment.
Shutdown 12.0 Battery Normal.
NOTE : Display flashes voltage reading with single
loud tone. Repeats every 30 minutes until
condition fixed.
The electrical system voltage is displayed on the
Cab Display Module (CDM) when selected with
the SELECT button on the Ground Speed Lever
(GSL) handle or the SELECT switch on the CDM.
The display indicates the condition of the battery
and alternator. Refer to table.
6.3.5.9 Engine Warning Lights
There are four engine warning lights that
illuminate if abnormal conditions occur while the
engine is running. The engine warning lights
should not be illuminated under normal operating
conditions.
OPERATING RANGE
DISPLAY
Displays Malfunction Code
Refer to Error Codes at End of this Manual
CAUTION
Illuminates Yellow
Prompt Attention Is Required.
Refer to Display Code
STOP
Illuminates Red
Stop Engine Immediately
Refer to Display Code
WATER IN FUEL
Illuminates Yellow
Service Recommended