HEADER OPERATION – D SERIES
169469/169470/169471
101
Revision E
6.5.2 HEADER
DETACHMENT
a. Raise the header fully with the HEADER UP
switch on the Ground Speed Lever (GSL). Stop
engine, and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
b. Engage lift cylinder stops on both lift cylinders.
Refer to Section 6.4.1 Header Lift Cylinder Stops.
c. Remove pin (A) from header leg on both sides.
d. Lower header stand (B) by pulling spring loaded
pin (C). Release pin to lock stand.
e. Remove pin from location (D) to disengage float
springs, and insert in storage hole (E). Secure with
lynch pin.
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (E), and
NOT installed at hole location (D).
f. Disengage lift cylinder stops.
g. Start engine, choose a level area, and lower
header to the ground. Stop engine, and remove
key.
h. Disconnect header drive hydraulics (F) and
electrical harness (G) from header. Refer to the
draper header operator’s manual.
(continued next page)
D
E
HEADER UP
HEADER TILT UP
HEADER DOWN
HEADER
TILT DOWN
C
A
B
G
F
Summary of Contents for M205 2012
Page 1: ...M205 Self Propelled Windrower OPERATOR S MANUAL Part 169469 Rev E 25 ...
Page 11: ...SAFETY 169469 169470 169471 9 Revision E ...
Page 13: ...SAFETY 169469 169470 169471 11 Revision E Safety Sign Locations cont d ...
Page 186: ...MAINTENANCE AND SERVICING 169469 169470 169471 184 Revision E 7 10 13 3 Fuse Box Decal ...