MacDon M205 2012, Operator'S Manual, Page: 54 / 230

OPERATOR’S STATION
169469/169470/169471
52
Revision E
5.18.5 CAB DISPLAY MODULE (CDM)
PROGRAMMING
The monitoring system requires programming for
each header, and the
header must be attached
to the windrower so that the CDM recognizes the
type of header. Programming the system may be
accomplished with or without the engine running.
If the engine is running, the transmission must be
in Neutral. If the engine is not running, the ignition
must be ON. Exit programming mode at any time
by pressing the PROGRAM switch or by turning
off the ignition.
The system only needs to be programmed once
for each header. The Operator may make
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine. Refer to paragraph 5.18.6 Setting
Guidelines for recommended settings. Most
functions have been pre-programmed at the
factory, but can be changed by the Operator if
required.
NOTE
Contact your Dealer for information
regarding software updates to the electronic
modules. Your Dealer will have the
necessary interface tools and access to the
latest software upgrades.
Proceed as follows to program the CDM:
IMPORTANT
Header must be attached to the windrower
so that the CDM can detect the type of
header (Header ID) and adjust the
programming mode accordingly.
a. Turn ignition key to RUN, or start the engine.
Refer to paragraph 6.3.5 Engine Operation.
b. Press PROGRAM and SELECT on CDM to enter
programming mode. Header ID code is displayed.
c. Press SELECT. TRACTOR SETUP? is displayed
on upper line.
d. Press . SET KNIFE SPEED? is displayed
e. Press or to change value on lower
line.
f. Press SELECT. KNIFE OVERLOAD SPD? is
displayed.
g. Press or to change value on lower
line.
h. Press SELECT. OVERLOAD PRESSURE? is
displayed.
i. Press or to change value on lower
line.
j. Press SELECT to advance to the next L1 item and
press arrow keys to change values. Refer to
Detailed Programming Instructions on following
pages.
k. Press PROGRAM to exit programming mode
when finished entering desired values.
MENU ITEM SCROLL BACKWARD
Displays Value under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
MENU ITEM SCROLL FORWARD
Displays Value under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line – Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor into Program
Mode with PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
SIDE DISPLAY
Displays Software Revision Status
Upper Line – C### (CDM)
Lower Line – M### (WCM)
PROGRAM SWITCH
Places Monitor into Program Mode
Press While Depressing SELECT Switch
Press to Exit Program Mode.
* Fast scroll applies only when changing
KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE.