MacDon M205 2012, Operator'S Manual, Page: 126 / 230

MAINTENANCE AND SERVICING
169469/169470/169471
124
Revision E
7 MAINTENANCE AND
SERVICING
The following instructions are provided to assist
the Operator in the use of the M205 Windrower.
Detailed maintenance, service, and parts
information are contained in the technical manual
and Parts Catalog that are available from your
Dealer.
7.1 PREPARATION FOR SERVICING
WARNING
To avoid personal injury, before servicing
adapter/header or opening drive covers:

Fully lower the header. If necessary to
service in the raised position, always
engage lift cylinder stops.

Disengage drives.

Stop engine, and remove key.

Wait for all moving parts to stop.
7.1.1 WELDING PRECAUTIONS
IMPORTANT
High currents and voltage spikes associated
with welding can cause damage to
electronic components. Before welding on
any part of the windrower or an attached
header, disconnect all electronic module
harness connections as well as the battery
cables. These electronic modules include;

Engine Control Module (ECM)

Windrower Control Module (WCM)

Cab Display Module (CDM)
7.2 RECOMMENDED SAFETY
PROCEDURES

Wear close-fitting clothing and
cover long hair. Never wear
dangling items such as scarves
or bracelets.


Wear protective shoes with slip-resistant
soles, a hard hat, protective glasses or
goggles and heavy gloves.

If more than one person is servicing the
machine at the same time, be aware that
rotating a driveline or other mechanically
driven component by hand (for example,
accessing a lube fitting) will cause drive
components in other areas (belts, pulleys,
and sickle) to move. Stay clear of driven
components at all times.

Be prepared if an accident should occur.
Know where the first aid kit and fire
extinguishers are located
and how to use them.

Keep the service area clean
and dry. Wet or oily floors
are slippery. Wet spots can
be dangerous when working
with electrical equipment. Be
sure all electrical outlets and
tools are properly grounded.

Use adequate light for the job at hand.

Replace all shields removed or opened for
service.

Park on a level surface when possible.
Block wheels securely.

Use only service and repair parts made or
approved by the equipment manufacturer.
Substituted parts may not meet strength,
design or safety requirements.

Keep the machine clean. Never use
gasoline, naphtha or any volatile material
for cleaning purposes. These materials
may be toxic and/or flammable.