MAINTENANCE AND SERVICING
169469/169470/169471
152
Revision E
b. Change primary filter (C) as follows:
1. Clean around the filter head (F).
2. Disconnect Water In Fuel (WIF) sensor (G)
from bottom of filter.
3. Turn drain valve (H) by hand counterclockwise
until draining occurs, and drain filter into a
container.
4. Remove filter (C) with a filter wrench.
5. Clean gasket mating surface.
IMPORTANT
Do not pre-fill filter with fuel. Pre-filling can
contaminate the fuel system.
6. Screw the new filter (C) onto the filter mount
until the gasket contacts the filter head.
7. Reconnect WIF sensor (G).
8. Tighten the filter an additional 1/2 to 3/4 turn
by hand.
IMPORTANT
Do not use a filter wrench to install the filter.
Over-tightening can damage the gasket and
filter.
c. Change secondary filter (D) as follows:
1. Clean around the filter head (J).
2. Place a container under the filter to catch split
fluid.
3. Remove filter (D) with a filter wrench.
4. Clean gasket mating surface.
IMPORTANT
Do not pre-fill filter with fuel. Pre-filling can
contaminate the fuel system.
5. Screw the new filter onto the filter mount until
the gasket contacts the filter head.
6. Tighten the filter an additional 1/2 to 3/4 turn
by hand.
IMPORTANT
Do not use a filter wrench to install the filter.
Over-tightening can damage the gasket and
filter.
d. Open fuel valve (E) under fuel tank.
e. Prime the system. Refer to Section 7.8.6.5 System
Priming.
f. Close engine compartment hood.
E
F
G
H
C
D
J
Summary of Contents for M205 2012
Page 1: ...M205 Self Propelled Windrower OPERATOR S MANUAL Part 169469 Rev E 25 ...
Page 11: ...SAFETY 169469 169470 169471 9 Revision E ...
Page 13: ...SAFETY 169469 169470 169471 11 Revision E Safety Sign Locations cont d ...
Page 186: ...MAINTENANCE AND SERVICING 169469 169470 169471 184 Revision E 7 10 13 3 Fuse Box Decal ...