MacDon M205 2012, Operator'S Manual, Page: 17 / 230

SAFETY
169469/169470/169471
15
Revision E
13. MD #166457
General hazard pertaining to machine
operation and servicing.
Run-over hazard
CAUTION
To avoid injury or death from improper or
unsafe machine operation:
i. Read the Operator’s manual, and
follow all safety instructions. If you do
not have a manual, obtain one from
your Dealer.
ii. Do not allow untrained persons to
operate the machine.
iii. Review safety instructions with all
Operators annually.
iv. Ensure that all safety signs are
installed and legible.
v. Make certain everyone is clear of
machine before starting engine and
during operation.
vi. Keep riders off the machine.
vii. Keep all shields in place, and stay
clear of moving parts.
viii. Disengage header drive, put
transmission in neutral and wait for all
movement to stop before leaving
Operator’s position.
ix. Shut off engine and remove key from
ignition before servicing, adjusting,
lubricating, cleaning, or unplugging
machine.
x. Engage locks to prevent lowering of
header or reel before servicing in the
raised position.
xi. Use slow moving vehicle emblem and
flashing warning lights when
operating on roadways unless
prohibited by law.

Machine will move if steering wheel is turned
while engine is running.

Steering response is opposite to what is
normally expected when backing up. Turn
bottom of steering wheel in direction you want
to go.

Always move ground speed lever to slow end
of range before shifting high-low speed
control.

Stop engine, and remove key from ignition
before servicing, adjusting, lubricating,
cleaning, or unplugging the machine.
14. MD #166461
Hot fluid under pressure hazard.
CAUTION

Coolant is under pressure and may be hot.
Never remove radiator cap when engine is
hot.