MAINTENANCE AND SERVICING
169469/169470/169471
200
Revision E
7.12.2.5 Formed Caster Wheel
Removal/Installation
DANGER
To avoid severe personal injury or death
caused by machine runaway, shut off engine
and remove key before performing any of the
following checks and/or adjustments.
a. Remove the caster wheel as follows:
1. Park windrower on level ground, and block all
wheels.
2. Place GSL in N-DETENT, shut down engine,
and remove key.
3. Raise end of walking beam using a jack
(4,000 lb [1,816 kg]) capacity (or other
suitable lifting device) until the wheel is slightly
off the ground.
4. Undo the six wheel bolts (A), and remove
wheel from hub.
b. Install the caster wheel as follows:
1. Position wheel on hub, and install wheel bolts
(A).
2. Torque bolts (A) to 120 lb-ft (163 N·m), using
the tightening sequence shown on previous
page.
3. Lower windrower, and remove jack.
7.12.2.6 Caster
Wheels
Anti-Shimmy
Dampeners
Each caster is equipped with a fluid filled
anti-shimmy dampener (B).
The mounting bolts (C) need to be checked
periodically for security. Refer to Section 7.13
MAINTENANCE SCHEDULE.
Inboard bolt should be tightened to
100 lb-ft (135 N·m).
Outboard bolt should be tightened to
85 lb-ft (115 N·m).
A
B
C
Summary of Contents for M205 2012
Page 1: ...M205 Self Propelled Windrower OPERATOR S MANUAL Part 169469 Rev E 25 ...
Page 11: ...SAFETY 169469 169470 169471 9 Revision E ...
Page 13: ...SAFETY 169469 169470 169471 11 Revision E Safety Sign Locations cont d ...
Page 186: ...MAINTENANCE AND SERVICING 169469 169470 169471 184 Revision E 7 10 13 3 Fuse Box Decal ...