MacDon M 2009 Series, Assembly Instructions Manual

Page: 83 / 117

UNLOADING AND ASSEMBLY
Form 169542
83
Revision F
f. Connect center-link:
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust position of the center-link cylinder (E)
with the REEL UP an d REEL DOWN
switches, and HEADER TILT switches on the
GSL to position the hook above the header
attachment pin.
IMPORTANT
Hook release (J) must be down to enable
self-locking mechanism. If the release i s
open (up), manually push it down after hook
engages header pin.
2. Push the REEL DOWN switch on the GSL to
lower the center-link onto the header until it
locks into position (release (J) is down).
3. Check that center-link is locked onto header
by pressing the REEL UP switch on the GSL.
4. Proceed to step g. on next page.
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT (M155 OPTIONAL)
1. Activate HEADER TILT cylinder switches on
GSL to extend or retract center-link cylinder
(E) so that the hook lines-up with the header
attachment pin.
2. Stop engine, and remove key from ignition.
3. Push down on rod end of link cylinder (E) until
hook engages pin on header, and is locked.
IMPORTANT
Hook release (J) must be down to enable
self-locking mechanism. If the release i s
open (up), manually push it down after hook
engages header pin.
4. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
5. Proceed to step g. on next page.
(continued next page)
E
J
J
E
HEADER UP
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER DOWN