MacDon M 2009 Series, Assembly Instructions Manual

Page: 21 / 117

UNLOADING AND ASSEMBLY
Form 169542
21
Revision F
STEP 8. REMOVE WHEEL AND
PLATFORM SUPPORT
a. Remove cross brace, and the two upright
supports from frame.
b. Remove the cross member over the h ood, and
the two uprights on either side.
STEP 9. ASSEMBLE
WINDROWER SUPPORT
STAND
Special stands for assembling the windrower are
available from the facto ry. If this sta nd is not
available, an equivalent support system can be
used.
The stand must be capable of holding a 20,000 lb
(9,072 kg) load.
Assemble factory stand as follows:
a. Remove all shipping materials from stand.
b. Arrange forward and rear stands on level ground,
so that attachment lugs on each stand face each
other.
c. Attach four suppo rt tubes to stands a s shown
with hardware provided, and tighten.
d. Set up air control valve tripod. Remove plug on
valve, and install a 100 psi (689 kPa) air line.
e. The stand is now ope rational. Instructions for
use are given in the appropriate sections.
WARNING

Use stand only as instructed in this
manual. Do not use stand for any other
purpose.

Do not pressurize air bags beyond 120 psi
(827 kPa).
FORWARD STAND
REAR STAND
SUPPORT