MacDon M 2009 Series, Assembly Instructions Manual

Page: 33 / 117

UNLOADING AND ASSEMBLY
Form 169542
33
Revision F
B. M155
a. The hydraulic hoses under the cab may require
proper placement under the existing clip. If
necessary, proceed as follows:
1. Locate hose clip under the cab, and remove
clip.
2. Position hose 111323 (orange tie) and hose
111324 with tee (white tie), as sho wn under
the center of the clip, and loosely install two
bolts and nuts. Part numbers are located on
hoses. (If M200, place another hose 1132A
with tee under clip)
3. Position remaining hoses under clip as shown,
and tighten bolts.
b. Connect hoses as follows, using colored plastic
cable ties as a guide.
1. Locate two hoses 111327 (green tie s) in
frame opening, and existing tee fitting (green
tie).
2. Remove caps on green lines and tee, and
make connections. Tighten fittings.
NOTE
Remove caps on tee last to minimize oil
loss.
3. Position hoses into frame.
4. Locate two h oses (white ties) in side frame,
and hose 111324 with tee (white tie).
5. Remove caps, make connections, and tighten
fittings.
6. Push hoses into frame.
(continued next page)
111327 GREEN
111324 WHITE ‘T’
VIEW LOOKING FORWARD
111323 BLUE
111324 WHITE ‘T’
111327 GREEN ‘T’
111328 WHITE
111557 YELLOW
111323 ORANGE
111324 (M200 ONLY)
(NOT SHOWN)