MacDon M 2009 Series, Assembly Instructions Manual

Page: 82 / 117

UNLOADING AND ASSEMBLY
Form 169542
82
Revision F
CAUTION
Check to be sure all bystanders have cleared
the area.
b. Start engine, and activat e HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
IMPORTANT
If the center-link is too lo w, it may contact
the header as the windrower approaches
the header for hook-up.
c. If necessary, adjust position of the h ydraulic
center-link (E) so that the hook (F) is above the
attachment pin on the header by o ne of the
following 2 methods (shown in next column):
1. If the optional center-link self-alignment kit is
installed, activate the REEL UP switch on the
GSL to raise the center-link (E).
2. Without the self-alignment kit, re-locate the pin
(G) at the frame linkage as required to raise
the center-link (E).
d. Slowly drive windrower forward so that feet (H)
on windrower enter boots (B) on the header.
e. Continue to drive slowly forward until feet engage
the boots, and header nudges forward.
(continued next page)
B
H
HEADER UP
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER DOWN
E
F
E
G