MacDon M 2009 Series, Assembly Instructions Manual

Page: 62 / 117

UNLOADING AND ASSEMBLY
Form 169542
62
Revision F
g. Lower the center-link onto the header with REEL
DOWN switch until it locks into position (handle is
down).
h. Raise the h eader fully with the HE ADER UP
switch on the GSL. Stop engine and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift
cylinder stops when working on or
around raised header.
i. Engage lift cylinder stops on both lift cylinders.
j. Install pin (F) throug h header leg, (engaging
U-bracket in lift linkage) on both sides, and secure
with hairpin.
k. Raise header stand (H) t o storage position by
pulling pin (J), and lifting stand into uppermost
position. Release pin (J).
CAUTION
Check to be sure all bystanders have
cleared the area.
l. Remove pin from storage position (K) in linkage,
and insert in hole (L) to engage float springs.
Secure with hairpin.
m. Disengage lift cylinder stops.
n. Start engine, and push HEADER DOWN switch on
GSL to lower header fully.
o. Stop engine, and remove key.
p. Connect header drive hoses (M) and electrical
harness (N) to header. Refer to the Draper
Header Unloading and Assembly Instruction.
q. Connect reel hydraulics (O ) at RH sid e of
windrower. Refer to the Draper Header Unloading
and Assembly Instruction.
r. Start engine, and raise and lower header and reel
a few times, to allow trapped air to pass back to
the reservoir.
H
J
F
O
N
M
L
K