MacDon M 2009 Series, Assembly Instructions Manual

Page: 78 / 117

UNLOADING AND ASSEMBLY
Form 169542
78
Revision F
MECHANICAL LINK (M155, M105 OPTIONAL)
1. Stop engine, and remove key from ignition.
2. Loosen nut (H), and rotate barrel (J), to adjust
length so that other end lines-up with header
bracket.
3. Install pin (K), and secure with cotter pins.
4. Adjust link to required length for proper
header angle by rotating barrel (J). Tighten
nut (H) agai nst barrel. A slight tap with a
hammer is sufficient.
CAUTION
Check to be sure all bystanders have cleared
the area.
f. If engine is not running, start engine. Press
HEADER UP switch to raise header to maximum
height.
NOTE
If one end of the header does not raise
fully, the lift cylinders require re-
phasing. If re-phasing is needed,
proceed as follows:
1. Press and hold HEADER UP switch until both
cylinders stop moving.
2. Continue to hold the switch for 3–4 seconds.
3. Cylinders are phased.
4.
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header, and before going under header for any
reason.
g. Cylinder stops are lo cated on both hea der lift
cylinders on the windrower. Engage lift cylinder
stops on both lift cylinders as follows:
1. Stop engine, and remove key from ignition.
2. Pull lever (L ), and rotate toward hea der to
release and lower cylinder stop (M) onto
cylinder.
3. Repeat for opposite lift cylinder.
(continued next page)
M
L
HEADER UP
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER DOWN
J
H
K