UNLOADING AND ASSEMBLY
Form 169542
71
Revision F
e. Remove hairpin on pin s (F), and rem ove pins
from header legs.
CAUTION
Check to be sure all bystanders have cleared
the area.
f. Start engine, and activat e HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
IMPORTANT
If the center-link is too lo w, it may contact
the header as the windrower approaches
the header for hook-up.
g. If necessary, adjust position of the h ydraulic
center-link (G) so that the hook (H) is above the
attachment pin on the header by o ne of the
following methods:
1. If the optional center-link self-alignment kit is
installed, activate the REEL UP switch on the
GSL to raise the center-link (G).
2. Without the self-alignment kit, re-locate the pin
(J) at the frame linkage as required to raise
the center-link (G).
h. Slowly drive windrower forward so that boots (D)
enter header legs (K). Continue to drive slowly
forward until lift linkages contact support plates in
the header legs, and header nudges forward.
i. Ensure that lift linkages are properly engaged in
header legs, contacting support plates.
(continued next page)
F
G
H
D
K
G
J
HEADER UP
HEADER TILT UP
REEL UP
REEL DOWN
HEADER DOWN
HEADER
TILT DOWN
Summary of Contents for M 2009 Series
