MacDon M 2009 Series, Assembly Instructions Manual

Page: 56 / 117

UNLOADING AND ASSEMBLY
Form 169542
56
Revision F
STEP 24. INSTALL AM/FM RADIO
Provision has been made for installation of AM/FM
radio. The mounting is designed to fit a DIN E
style radio with a depth
‘X’
= 161 mm, and having
a 5 mm threaded stu d centered on the rear fo r
support.
Provision has been made for adjustments, should
the radio fall outside these parameters.
NOTE
M105 configuration is slightly different,
but the installation procedure is the
same.
a. Ensure the ignition is turned to the OFF position.
b. Remove radio panel by removing four screws (A).
c. Remove screw and nuts (B) and (C) to remove
support (D) from panel. Retain metric nut (C)
and lockwasher.
d. Remove the cut-out by cutting the tabs (E) in the
panel. Remove sharp edges on panel.
e. Locate receptacle (F) (supplied with radio) in
opening, and secure by bendi ng tabs (G) on
receptacle against panel.
f. Insert radio into receptacle and attach radio
bezel. En sure radio locks into position, and
faceplate (H) is against the panel.
g. A six-pin connector for the radio is included in the
wiring harness. In order to mate properly with this
connector, the radi o must have a six-pin
connector (Packard #2977042), and have a
terminal arrangement as follows:
(continued next page)
A
B
C
D
E
H
X
G
F