UNLOADING AND ASSEMBLY
Form 169542
55
Revision F
STEP 23. REMOVE WINDROWER
FROM STAND
A. FACTORY STAND
a. Open valve on air supply control to rai se
windrower slightly, and take load off lift locks.
b. Release lift lock mechanism (3 places), and turn
keeper to keep lock in released position.
c. Lower machine to groun d by slowly re leasing
pressure to air bag system.
CAUTION
Ensure all three lifts have fully retracted and
are clear of windrower frame before driving
windrower ahead.
d. Start engine, and drive machine straight ahead,
leaving shipping support channels supported on
rear support stand.
B. FIELD-CONSTRUCTED STAND
a. Position a jack under the jack point of each drive
wheel leg, and another under the rear hitch.
b. Raise jacks to take weight off stan ds, and
remove stands.
c. Slowly lower windrower to ground, and remove
jacks.
Summary of Contents for M 2009 Series
