Lexmark Optra S 1250, User Manual

Page: 371 / 427

355
Notices
Notices
Reference
Without a Network Card Installed
Federal Communications Commission (FCC) Compliance Information
Statement
The Optra S laser printer, Type 4059, has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Oper-
ation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult your point of purchase or service representative for additional
suggestions.
The manufacturer is not responsible for any radio or television interference
caused by using other than recommended cables or by unauthorized changes or
modifications to this equipment. Unauthorized changes or modifications could
void the user's authority to operate this equipment.
Note: To assure compliance with FCC regulations on electromagnetic interfer-
ence for a Class B computing device, use a properly shielded and
grounded cable such as Lexmark part number 1329605. Use of a substi-
tute cable not properly shielded and grounded may result in a violation
of FCC regulations.
Any questions regarding this compliance information statement should be
directed to:
Director of Lab Operations
Lexmark International, Inc.
740 New Circle Road NW
Lexington, KY 40550
(606) 232-3000