Lenovo NeXtScale nx360 M4, Installation And Service Manual

Page: 44 / 738

Attention: If you set an administrator password and then forget it, there is no way to change, override, or
remove it. You must replace the system board.
• Remove the battery from the server, wait 30 seconds, and then reinstall it.
• Change the position of the power-on password switch (enable switch 3 of the system board switch
block (SW4) to bypass the password check (see “System-board switches and jumpers” on page 17
for more information).
1
2
3
1
2
3
NMI button
Lightpath button
UEFI boot
recovery jumper
Clear CMOS jumper
Figure 12. Power-on password switch
Attention: Before you change any switch settings or move any jumpers, turn off the server; then,
disconnect all power cords and external cables. See the safety information that begins “Safety” on page
v. Do not change settings or move jumpers on any system-board switch or jumper blocks that are
not shown in this document.
The default for all of the switches on switch block SW3 is Off.
30
IBM NeXtScale nx360 M4 Installation and Service Guide