Lenovo NeXtScale nx360 M4, Installation And Service Manual

Page: 164 / 738

always use an electrostatic-discharge wrist strap or other grounding system when you work inside the
server with the power on.
To install a 1.8-inch hard disk drive, complete the following steps.
Step 1. Read “Safety” on page v and “Installation guidelines” on page 89.
Step 2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see “Removing
a compute node from a chassis” on page 92 for instructions).
Step 3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node
with the bezel pointing toward you.
Step 4. Remove the cover (see “Removing the compute node cover” on page 105).
Step 5. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the cage upward.
1
2
1.8-inch SSD cage
Figure 76. Lift the 1.8-inch hard disk drive cage upward
Step 6. Remove the filler panel, if one is present.
Step 7. Touch the static-protective package that contains the disk drive to any unpainted metal surface
on the server; then, remove the disk drive from the package.
Step 8. Make sure that the tray handle is open; then, carefully slide the drive into the drive bay until the
drive snaps into place.
1.8-inch SSD
Figure 77. 1.8-inch hard disk drive installation
Step 9. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the cage downward until
the cage snaps into place.
150
IBM NeXtScale nx360 M4 Installation and Service Guide