WavePro 7 Zi and Zi-A Oscilloscopes
57
WP7Zi-GSM-E RevB
Probe Cal - Cable Deskew
- Opens the Probes Cal. dialog where
various Gain, Offset, Skew, Source, and Advanced controls are
available for probe signal calibration.
Another example is seen in the buttons appearing at the bottom of the
Measure
Px
dialogs. The button may be selected in order to display the
functions named on the buttons (sometimes labeled as
Actions
):
Using these buttons allow you to remain in the Measure dialog while
setting up a Math trace on a parameter measurement.
Message Bar
At the bottom of the oscilloscope display is a narrow message bar. The
current date and time are displayed at the far right. Status, error, or other
messages are also shown in this area.
Turning on Channels and Traces
Note
: If you want to display each trace on its own grid automatically,
enable Autogrid by touching
Display → Autogrid
from the menu bar.
On the front panel, press a channel select button to display the
trace label for that input channel and turn on the channel.
Turn on a math function trace by touching
Math → Math Setup...
from the menu bar. Touch the corresponding
On
checkbox to
activate the desired trace.
