L-3 Communications CEU, User Manual

Page: 141 / 312

STE User’s Manual User Functions
Rel. 2.6 5-9
Press: Result:
CHANGE Toggles between EIA-232 and EIA-530A.
SCROLL Advances display to REMOTE CONTROL DATA PORT RATE: menu (Paragraph 5-
1.8 )
BACK Return display to TERMINAL MANAGEMENT menu ( Figure 5-1 )
Press CHANGE to make settings
Press SCROLL if no change required or after change is made.
5-1.8 Remote Control Data Port Rate
When operating in remote control mode, the STE host data port can be configured to operate at either
38.4 kbps, or 115.2 kbps using the Remote Control data Port Rate Menu (
Figure 5-19 ).
This setting is applicable whenever the STE is accepting remote control commands, or is in remote
control mode and is configured for asynchronous data. Otherwise, if the STE is in front panel mode, the
STE host data port will operate at the preset rate for “off-line” operations (e.g. software download, ACL
load, etc), or at the data rate selected via the Mode menu selection.
If the STE is operating in remote control mode and while in remote control mode synchronous data
operation has been selected, the STE will operate at the Remote Control Data Port rate when accepting
remote control commands, but will operate at the selected synchronous data rate when transferring data
traffic. The default remote control data port rate setting is 38.4 kbps.
Figure 5-19. Remote Control Data Port Rate Menu
Press: Result:
CHANGE Toggles between 38.4 Kbps and 115 Kbps.
SCROLL Advances display to HANDSET SIDETONE: menu (Paragraph 5-1.8 )
BACK Return display to TERMINAL MANAGEMENT menu ( Figure 5-1 )
NOTE
The 115 kbps Remote Control Data Port rate is not available when the STE is
configured for operation on the TRI-TAC or BDI networks.
5-1.9 Handset Sidetone
The HEADSET SIDETONE function may be enabled or disabled by all authorized. The sidetone should
be left in the enabled state because you are accustomed to hearing a sidetone (your own voice as you
speak) in the handset earpiece. Refer to the menu hierarchy shown in the foldouts and the default setting
shown
Table 5-1 . The HANDSET SIDETONE menu ( Figure 5-20 ) is accessed in one of two ways:
1. In the DATA PORT menu ( Figure 5-18 ), press SCROLL, or
2. In an idle state press MENU , SELECT and then SCROLL as necessary to display Figure 5-20 .
REMOTE CONTROL DATA PORT RATE:
CHANGE BACK SCROLL
38.4 Kbps