Konica Minolta 7115F, Instruction Manual

Page: 290 / 327

12 Error Messages
12-20 Konica 7115F/7118F
MEMORY FULL The size of the data for the
scanned image has
exceeded the capacity of the
memory. Press the [AUTO RESET]
key, or turn the machine off,
then on again. (The scanned
data should be cleared from
the memory.)
(Flashing alternately)
PRESS ANY KEY
∗
PC PRINT
∗
MEMORY FULL
The image data received
from the computer has
exceeded the capacity of the
memory. Press the [AUTO RESET]
key, or turn the machine off,
then on again. (The received
image data should be cleared
from the memory.)
SET PLUG-IN COUNTER A counter key is not inserted. Insert the counter key.
UPPER TRAY FULL If the optional Job Tray is
installed and the paper in the
Upper Copy Tray has
reached the maximum
capacity, printing cannot
continue. Remove all paper from the
Upper Copy Tray of the Job
Tray.
(Flashing alternately)
REMOVE PAPER
TRAY MOVEMENT
ERROR The optional Job Tray is
installed and the paper in
either the Upper Copy Tray or
the Lower Copy Tray has
reached the maximum
capacity when the machine is
turned on, when copying
begins, when receiving a fax,
or when starting to print. Remove the paper from the
Upper Copy Tray or the
Lower Copy Tray of the Job
Tray, and then press the
[AUTO RESET] key.
(Flashing alternately)
PRESS ANY KEY
LINE PROBLEM • The telephone dialing
system or telephone wiring
system are not set
correctly.
• The telephone cable is not
attached correctly.
• Check the telephone
dialing system or
telephone wiring system
and use the appropriate
Initial Set mode function to
make the correct settings.
• Correctly connect the
telephone cable.
(Flashing alternately)
CHECK LINE
∗
COMM.ERROR
∗
(####)
• Communication is not
possible because of some
problem in the machine.
• Communication is not
possible because of a
problem with the recipient/
caller’s fax machine.
Check the transmission
results.
∗
REDIAL ALL FAILED
∗
All redial attempts failed
because either the recipient’s
line is busy or there was no
answer. Check the condition of the
recipient’s line, and then try
sending the fax again.
∗
MEM.FULL/TX CANCEL
∗
While sending a fax, the size
of the data for the scanned
image has exceeded the
capacity of the memory. • Retrieve all received faxes
stored in the memory.
• Send the fax by direct
transmission.
∗
MEM.FULL/RX
CANCEL
∗
While receiving a fax, the size
of the data for the scanned
image has exceeded the
capacity of the memory. Retrieve all received faxes
stored in the memory.
Message Cause Remedy