Kipp & Zonen SOLYS Gear Drive, Instruction Manual

Page: 75 / 112

- Pause (PA)
Enables to pause the actual tracking mode for a specified time (maximum 10 hours).
- Position (PO)
To retrieve or set the final position for all motors.
- Power save (PS)
To retrieve or set the power savings mode (1=enabled, 0=disabled).
- Change protection (PW)
Allows or disallows modification to be done by the web interface to the configuration.
- Change password (PW)
Most of the set commands desire a password which can be changed here.
- Queue status (QS)
To see the actual queue status (every positioning command (PO) is queued).
- Restart sun tracking (RE)
Enables to restart the sun tracking.
- Sun sensor scaling (SC)
To retrieve or set the scaling factor for each sun sensor quadrant along with the nominal scaling of the sensor.
- Serial number (SE)
To retrieve the serial number of the SOLYS.
- Sun intensity (SI)
Retrieves the current sun intensity.
- Sun speed (SP)
To retrieve or set the current sun speed. It is the speed at which the solar algorithm runs.
- Sun sensing parameters (SS)
To retrieve or set the amount of time over which each sun observation takes place and the intensity level below which the sun is
deemed to be obscured.
- Steps per revolution (ST)
To retrieve or set, from permanent memory, the number of stepping units in a complete revolution for all motors.
- Synchronize (SY)
To put the SOLYS in sleep mode in the current position after the last segment.
- Time (TI)
To retrieve or set the internal time (Universal).
75