Kipp & Zonen SOLYS Gear Drive, Instruction Manual

Page: 73 / 112

4.4 External commands
The following list of commands is available when connected to the SOLYS. More information is available in the SOLYS user interface
(web browser).
- Low level command
This enables to enter any command (two letters) without actually scrolling down the entire list of command (below) to search for the
correct one. This is normally used for experienced users. Behind every command in this document we will provide the two letter
command that can be entered in the low level command line.
- Accessory (AC)
This feature will tell you the presence of any accessory instruments (like a sun sensor).
- Adjust (AD)
This will enables to retrieve or set adjustments for the azimuth- and zenith motors.
- Maximum acceleration (AM)
This will enables to retrieve or set maximum operating acceleration for the azimuth- and zenith motors.
- Startup time (BE)
To retrieve the time at which the most recent session (reset) began.
- Checkout time (CH)
With this function you can actually set the SOLYS in sleep mode (and home position) for a desired period.
- Clear (CL)
Instantly stops all motors.
- Cold start (CO)
Resets the entire configuration to default and will reboot the SOLYS.
- Current position (CP)
Retrieves the current positions of all motors.
- Check ref and range (CR)
Sets the check reference and travel range state. 0 is off, 1 is on. Enables waiting in the reference sensors for one minute and moving
over the complete travel range. Only executed once after (re)starting tracking. This command is only permitted after protection has
been removed with the PWord command.
- Current time and positions (CT)
Retrieves the current time and positions of all motors.
- Error correction (EC)
To retrieve or set the error correction to be enabled (1) or disabled (0).
73