Kipp & Zonen SOLYS Gear Drive, Instruction Manual

Page: 70 / 112

4.2.8 Communication
When a SOLYS is connected via the RS-485 port (via RS-485 to USB connection) an extra tab ‘Communication’ is available to set
communication parameters. This allows you to:
Set and change ‘Serial Setting’
Network settings are used to set auto or manual IP address method for network communication. When set to manual, the IP
parameters can be entered.
Finally ‘Commands’ lets you clear and reset the following parameters:
- Clear Account (revert to defaults)
- Clear IP (Set to default Network parameters, auto IP)
- Clear Serial (Set to default serial parameters)
- Clear Track (reset sun tracking, identical to cold reset)
- Clear All (reset all tracking and communication parameters)
- Serial Break (reset the SOLYS to default comm. Parameters, after 5 seconds switch to stored configuration)
- Reset Track (restart sun tracking)
- Warm Reset (restart the SOLYS)
- Cold Reset (set configuration to default and restart)
Tracking Status Instrument Status Configuration Browser
Serial Setting Network Settings Commands
Netwerk Settings
Address method
IP Address
NetMask
Default gateway
manual
192.168.75.90
255.255.255.0
0.0.0.0
Load Apply
COM10
Tracking Status Instrument Status Configuration Browser
Serial Setting Network Settings Commands
Clear Account
Revert user account and operational mode to defaults
Clear Account
COM10
Tracking Status Instrument Status Configuration Browser
Serial Setting Network Settings Commands
Serial Port Settings
Baudrate
Parity
Databits
Stopbits
19200
None
8
One
Load Apply Synchronize
COM10
70