17
Key
Name
Function
RUN
Run key
In panel control mode, press this key to run the drive.
STOP/RST
Stop/reset key
Press this key to stop or reset the drive.
Rotary knob
Frequency setting
rotary knob
Rotate it to set the frequency.
5.1.2 Function Descriptions of LED and Indicators
The operation panel consists of a 4-digits eight
segments LED display, 3 unit indicators and 1 status
indicator as shown in Fig.5-1. The LED display can
display the status parameters, function codes and error
codes of the drive. 1 status indicator,its description is
shown in table 5-2
Table 5-2
Indicator
Status Current status of drive
Running
indicator(RUN)
Off
Stop
On
Running
5.1.3 Display status of operation panel
CV100 operation panel can display the parameters in
stopping status, running status, parameters editing
status..
1. Parameters displayed in stopping status
When the drive is in stop status, the operation panel
displays the stopping staus parameter. Pressing the
SHIFT key can display different stop status parameters
(Defined by function code b4.05)
2. Parameters displayed in running status
When the drive receives operating command, it starts
running and its panel will display the running status
parameters, the RUN indicator turns on.The unit
indicator display the unit of the parameter, by pressing
the SHIFT key can display different operation
parameters (Defined by function code b4.05)
3. Parameters displayed in error status
When the drive detects a fault signal, the panel will
display the flashing fault code..
Press the SHIFT key to display the stop staus
parametere and error code. By pressing the STOP/RST,
control terminal or communication command to reset
the error. If the error still exists, then the panel keeps
displaying the error code.
4. Parameter editing status
When the drive is in stop, running or error state, press
MENU can enter edit status(If password needed,
please refer to description of A0.00),. Edit state
displays in 2-level menu, they are: function codegroup
or function code number→function code parameter
value. You can press ENTER to enter parameter
displayed status. In function parameter displayed
sttatus, press ENTER to save the settings, and press
MENU to exit the menu.
5.1.4 Panel Operation
Various operations can be done on the operation
panel,follows are 5 common examples. Refer to
parameter list in chapter 9 for detail function code
description.
Example 1
：
Set parameters
Example: Change the value in A0.03 from 50.00Hz to
30Hz
1. In the stop parameter displaying state, press MENU
to enter the fiest level A0.00;
2. Press
∧
to change A0.00 to A0.03;
3. Press ENTER to enter the second level menu
4. Press the SHIFT to change the marker to the highest
bit
5. Press the
∨
to change the 50.00 to 30.00
6. Press the ENTER to confirm above change and back
to the fist level menu. Then the parameter is changed
successfully.
The above operations are shown in following picture.
