Reference Waveforms
Voltage, current, power, and math waveforms can be saved to four nonvolatile reference
waveform locations, or to a USB drive. You can display one reference waveform at a time and
compare it against other waveforms. To scale and position the displayed reference waveform,
press
[Ref]
to light the LED to its left and use the knobs above and below the
[Ref]
key. You can
also adjust waveform skew, and you can optionally display scale, offset, and skew information.
To save a reference waveform
1.
Press
[Ref] > Display Ref
. Turn the
Entry
knob to select a reference waveform location.
Then, either push the
[Entry]
knob or press
Display Ref
again.
2.
Press
Source
and turn the
[Entry]
knob to select the source waveform.
3.
Press
Save to R1/R2/R3/R4
to save the waveform.
To clear a reference waveform
1.
Press
[Ref] > Display Ref
. Turn the
Entry
knob to select a reference waveform location.
2.
Press
Clear R1/R2/R3/R4
.
Reference waveforms are also cleared by a Factory Default.
To display a reference waveform and associated information
1.
Press
[Ref] > Display Ref
. Turn the
Entry
knob to select a reference waveform location.
2.
Press
[Ref]
to enable/disable the reference waveform display.
3.
Press
[Ref] > Display Info
to display a box summarizing the reference waveforms.
To scale and offset a reference waveform
1.
Make sure the scale and position knobs above and below the
[Ref]
key are selected for the
reference waveform. If the arrow to the left of the
[Ref]
key is not illuminated, press
[Ref]
.
2.
Upper (scale) and lower (position) knobs adjust the reference waveform.
156
Keysight IntegraVision PA2200 Series Power Analyzers Operating and Service Guide
