Juniper ULTRA-RUGGED FIELD PC, Reference Manual, Page: 162 / 170

¼ inch (6 mm) gap
6. If you inserted a camera SD
card, insert large foam pieces
inside the top of the cap to keep
the camera in place. Stack
enough foam in the top of the
cap so that when you slide the
cap into place with little pres-
sure, a ¼ inch (6 mm) gap re-
mains between the cap and the
Field PC. This gap closes when
you secure the cap in step 8.
8
5. Once you have inserted your card(s), tighten the
four small side screws until the top of each screw
is flush with the outside
of the gasket piece.
CAUTION:
Before removing
an inserted card,
loosen the four small
side screws by
1
/
8
inch
(3 mm)
.