Juniper JUNOSE 11.0, Command Reference Manual

Page: 535 / 1486

debug isis
Syntax
debug isis isisLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
no debug isis isisLog
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Displays debug-related information about selected IS-IS log parameters. This command
manipulates the same log as the Global Configuration
log commands. The no version
disables debugging display.
Options
isisLog— IS-IS log of interest; one of the following options:
■
■
adj-packets—IS-IS adjacency-related packets, such as hello packets sent and
IS-IS received adjacencies going up and down
■
mpls traffic-eng advertisements—MPLS traffic-engineering agent
advertisements
■
mpls traffic-eng agents—MPLS traffic-engineering agents
■
snp-packets—IS-IS CSNPs/PSNPs
■
spf-events—Shortest path first events
■
spf-statistics—SPF timing and statistic data
■
spf-triggers—SPF triggering events
■
update-packets—Update-related packets
■
severity—Specifies the minimum severity of the log messages displayed for the
selected category; described either by a descriptive term—
severityValue —or by
a corresponding number— severityNumber —in the range 0–7; the lower the
number, the higher the priority:
■
emergency or 0—System unusable
■
alert or 1—Immediate action needed
■
critical or 2—Critical condition exists
■
error or 3—Error condition
■
warning or 4—Warning condition
■
notice or 5—Normal but significant condition
■
info or 6—Informational message
■
debug or 7—Debug message
debug isis
■ 493
Chapter 5: D Commands