Juniper JUNOSE 11.0, Command Reference Manual, Page: 1247 / 1486

line
Syntax
line { console lineNumber | vty lineRangeStart [ lineRangeEnd ] }
no line vty lineNumber
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Opens virtual terminal lines or the console line and allows you to configure the lines.
By default five vty lines (0–4) are open. The
no version removes a vty line or a range
of lines from your configuration; users will not be able to run Telnet, SSH, or FTP to
lines that you remove. When you remove a vty line, the router removes all lines
above that line. For example,
no line vty 6 causes the router to remove lines 6
through 29. You cannot remove lines 0 through 4.
NOTE: Once lines are open, login is enabled by default. Before users can access the
lines, you must configure a password, disable login using the no login command,
or configure AAA authentication on the line.
Options
■
console—Specifies the console line
■
vty—Specifies vty lines
■
lineNumber— Number of a single line; 0 for the console line
■
lineRangeStart —Start of the vty line range; a number from 0–29
■
lineRangeEnd —End of the vty line range; a number from 0–29
Mode
Global Configuration
line
■ 1205
Chapter 12: L Commands