Juniper JUNOSE 11.0, Command Reference Manual

Page: 123 / 1486

adapter accept
Syntax
adapter accept adapterSpecifier
Release Information
Command introduced in JUNOSe Release 7.1.0.
Description
Erases from NVS the type and configuration of the previous I/O adapter (IOA) in the
specified IOA bay, and allows you to configure a new IOA. Issue this command after
you have installed a different type of IOA in an IOA bay. You can use this command
only when the state of the IOA is not present or disabled (mismatch). There is no
no
version.
NOTE: Issuing this command reboots the line module associated with the IOA, but
it does not accept its configuration.
To accept the configuration of the line module and its associated IOAs, issue the slot
accept command.
Options
adapterSpecifier —Particular IOA in the format slot/adapter :
■
■
slot —Number of the chassis slot; for E120 routers, in the range 0–5; for
E320 routers, in the range 0–5 or 11–16
■
adapter —Identifier for the IOA within the chassis slot, either 0 or 1, where:
■
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
■
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
Mode
Global Configuration
adapter accept
■ 81
Chapter 2: A Commands