Juniper JUNOSE 11.0, Command Reference Manual

Page: 406 / 1486

clear bgp ipv6
Syntax
clear bgp ipv6 [ unicast | multicast | vpnv6 | route-target signaling ]
[
ipAddress | ipv6Address | peer-group peerGroupName | * ] [ vrf vrfName ]
[ soft [ in | out ] ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
ipv6Address variable added in JUNOSe Release 8.0.0.
route-target signaling keywords added in JUNOSe Release 8.2.0.
Description
Resets the IPv6 BGP session. If the soft option is not used, brings down the underlying
TCP connection and then brings it back up again, causing both peers to resend their
complete BGP routing table. If the
soft out option is used, the BGP speaker reapplies
outbound policy and resends all routes to the specified peer(s). If the soft in option
is used, the BGP speaker reapplies inbound policy to the routes received from the
specified peers. This is possible only if soft reconfiguration inbound has been enabled
for the peer or the peer supports the route-refresh capability. There is no
no version.
Options
■
unicast—Clears the unicast routing table; the default option
■
multicast — Clears the multicast routing table
■
vpnv6 — Clears the VPNv6 unicast routing and forwarding table
■
route-target signaling—Clears the route-target membership information
■
ipAddress —IP address of identified BGP neighbor to clear
■
ipv6Address —IPv6 address of identified BGP neighbor to clear
■
peerGroupName —Name of a BGP peer group to clear
■
*—Clears all connections
■
vrfName —Name of a virtual routing and forwarding instance to clear
■
soft—Specifies soft reconfiguration
■
in—Triggers inbound soft reconfiguration
■
out—Triggers outbound soft reconfiguration
Mode
Privileged Exec
364 ■
clear bgp ipv6
JUNOSe 11.0.x Command Reference Guide A to M