Jungheinrich EFX 410, Operating Instructions Manual

Page: 211 / 404

Fault Possible Cause Remedy
Rapid travel
disabled – Load handler raised
above 0,5 m.
– Lower the load handler below 0,5 m.
– Attachment is not in
the home position
– Traverse the attachment to the home
position (see page 192).
– WG search mode
activated
– Manoeuvre truck onto the guide wire or
switch off wire guidance mode (see
page 164).
– No reference run
performed
– Carry out a reference run, see
page 147.
– Load in scanning
range of personal
protection system
laser scanner
– Raise the main lift until the "protection
field infringement" symbol is no longer
displayed.
Truck cannot
be steered – Truck not operational – Carry out all remedial measures listed
under “Truck does not start”.
– Automatic guidance
switched on
– Press the “switch automatic guidance
on/off” key and switch off "travelling in
narrow aisle".
1901 – Accelerator pedal
pressed during
power up test
– Do not press the accelerator pedal,
switch truck on and off again.
2902 – "Hydraulic functions"
control lever applied
during power-up test
– Do not apply the "hydraulic functions"
control lever; switch truck off and on
again.
3670 – Truck has left the
guide wire
– Restore wire guidance
(see page 223).
3752 – Truck has left the
guide wire
– Restore wire guidance
(see page 223).
4916 – During the power-up
test a "functions" key
under the driver's
display and/or a key
on the numerical
keypad has been
pressed
– Do not press "functions" key or keys on
the numerical keypad; switch the truck
off and back on again.
209
04.19 en-GB