JUKI SC-956, Instruction Manual

Page: 13 / 185

– 8 –
1) Attach the terminals of power cord ❶ coming
from the electrical box to reactor box PCB
asm.
❷ and reactor box mounting plate ❸ .
Connect brown wire A to the first connector
and blue wire B to the third connector respec-
tively from the top of terminal block on the
reactor box PCB asm. using screws. Connect
green/yellow wire
C to reactor box mounting
plate ❸ with earth setscrew ❹ .
2) Attach cable clip ❺ to the power cord com-
ing from the electrical box. Then, attach the
power cord together with the cable clip to
reactor box mounting plate
❸
with cable clip
setscrew ❻ .
3) Attach cord bushes ❽ to input/output cables
❶ and ❼ of the reactor box. Attach both
bushes in the same manner.
4) Attach reactor box cover to reactor box
mounting plate ❸ with four reactor-box cover
setscrews ❾ .
At this time, fix cord bushes
❽
attached to
input/output cables ❶ and ❼ in the concave
section on reactor box cover to eliminate a
gap between reactor box and cover .
5) Secure reactor box to the undersurface of
table with four accessory wood screws .
6) Secure two cables coming from reactor
box to the table with accessory cable clip
and wood screw .
❼
❽
❽
❶
❾
❽
❸
❸
❶
❷
❹
A
B
❻
❺
C
❾
2-7. Installing the reactor box (Only for the EU type models)
2-8. Connecting the power switch cable
Fix power switch ❶ under the machine table with
wood screws
❷
.
Fix the cable with staples ❸ supplied with the ma-
chine as accessories in accordance with the forms
of use.
2-8-1. Installing the power switch
❶
❷
❸
Electrical box
(EU type models:
Reactor box)