JUKI SC-956, Instruction Manual

Page: 11 / 185

– 6 –
2-4. Installing the thread stand
Assemble the thread stand, set it up on the ma-
chine table using the installation hole in the table
and tighten nut
❶ gently.
When you use power supplied by the overhead
power line, pass the power supply cord through
hollow spool rest rod
❷ .
❷
❶
300 mm from the top surface of table
2-5. Installing the control box
0.8 mm
❷
❸
❹
❺
❻
❶
1) Secure toothed washer ❷ and vibration-proof rubber ❸ to control box ❶ . (At four locations)
* Tighten the toothed washer until it protrudes the control box surface by 0.8 mm.
2) Secure control box mounting plate
❹ to the control box with plain washers ❺ and nuts ❻ . (At
four locations)
* Secure the mounting plate by fitting the screws against the U-groove in the mounting plate.
2-5-1. Preparing for installation of the control box