JR ProPo XG11, Operation Manual

Page: 61 / 124

59
▋ Flaperon▋Mixing【FLAPERON▋MIX】
▋ ▋ Function▋Explanation
This function allows the setting of Flaperon mixing.
"Aileron -> Flap Mixing" �������� This mixes from Aileron to flap, to use the flaps as Ailerons -
therefore the roll rate can be increased.
"Flap -> Flaperon Mixing" �������� This mixes from Flap to Aileron, to use the Ailerons as Flaps.
"Flap -> Elevator Mixing" �������� This mixes from Flap to Elevator, to correct Pitch variation caused by
flap extension.
▋ ▋ Setting▋Method
⿟ "Aileron -> Flap Mixing"
It is possible to set right and left control surfaces independently for each flight mode.
⿟ Include Aileron Trim Function (INCLUDE AILE TRIM)
It is possible to select mixing from Aileron to Flap with Aileron trim included (ACT) or excluded (INH). The
default setting is “INH”. To use this function set it to “ACT”.
⿟ "Flap -> Flaperon Mixing", "Flap -> Elevator Mixing"
It is possible to set right and left control surfaces independently on each flight mode.
⿟ Flap Lever Offset (FLAP LV OFFSET)
If a “LEVER” is set as the Input Device for the Flap channel, the Lever’s center (neutral position) can be offset if
necessary.
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー
⿟ Regarding this Mixing function from Flap, since the amount of travel is based on the Flap channel mixing from a
Slide lever or switch, an offset amount for the Flap trim or Camber is not included.
⿟ The Initial setting for the Flap rate is set to 0%. When mixing from Flaps, Set the Flap travel amount using the
Flap Rate first, before setting this mix.
▋ ▋ Caution▋Note
⿟ Actually operate the servos and carefully confirm the settings before flying.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING