JR ProPo XG11, Operation Manual

Page: 45 / 124

43
▋ Throttle▋Mixing【MIX → THRO】
▋ ▋ Function▋Explanation
When operating various controls on a helicopter, the rotor rotation may be reduced due to
loading. This function is a mixing function for implementing a correction for this effect. It will allow corrections
of the rotor rotation speed normally carried out by a governor. Each mix (from aileron, elevator, and rudder) can
be controlled from a separate switch.
▋
▋
Setting▋Method
Each mix from Aileron, Elevator, or Rudder can be switched on and off using an independent switch. After setting
the switches, please confirm the display of the operation function. Then set the mix amounts to the throttle for
each of the stick operation directions. The mix should be set to whichever direction the rotor rotation increases
when the operation is carried out.
⿟ As a rough guide to values, it is recommended that the aileron and elevator should be set to 10%-30%, and the
rudder should start from L10%/R15%.
▋ ▋ Caution▋Note
⿟ When using a governor, this function is not required, and the numerical values should all be set to zero.
⿟ Actually operate the servos and carefully confirm the settings before flying.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Mixing from Aileron to Throttle Mixing from Aileron to Throttle Mixing from Rudder to Throttle Mixing from Rudder to Throttle
Mixing from Elevator to Throttle Mixing from Elevator to Throttle
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー