JR ProPo XG11, Operation Manual

Page: 32 / 124

30
▋ Throttle▋Curve【THRO▋CURVE】
▋ ▋ Function▋Explanation
This function adjusts throttle servo operation in response to throttle stick operation. The servo
position can be set independently for a maximum of 7 point positions. In addition, an EXPO
(exponential) function is also incorporated to allow smooth throttle stick connection of each of
the points. This function is available in each Flight Mode for helicopters (maximum 5), and 2
modes for airplanes.
▋
▋
Setting▋Method
There are three initial curve points set at the slow, center, and high positions. To add a point, set the stick to the
desired position and press the “ADD” key. In the situation where a point is to be deleted, this should be carried
out using the “DEL” key. To change vales at each point, rotate the dial to move to and select the point that you
wish to change (inverse display). Then press the dial to select and change the numerical value.
⿟ Trim Offset
This functions the adjust throttle trim travel’s range limit.
▋ ▋ For▋Helicopter
There are five (5) flight modes (i.e. Normal, Stunt 1-4) available for helicopter throttle curves. Set each throttle
curve as desired for the particular flight condition.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Normal mode
Stunt mode
Adjusting point Display
Trim offset Trim offset
Current Flight Mode position
Each Adjusting point input
Position and output position
This changes the point connections to a Curve.
Point addition and deletion
Numerical Display of the
Stick input Position and
output position
Normal mode
Stunt mode
Adjusting point Display
Trim offset Trim offset
Current Flight Mode position
Each Adjusting point input
Position and output position
This changes the point connections to a Curve.
Point addition and deletion
Numerical Display of the
Stick input Position and
output position