JR ProPo XG11, Operation Manual

Page: 59 / 124

57
⿟ Selection of Trim
It is possible to allocate the Flap trim (FLAP TRIM) & Flaperon trim (FRPN TRIM) to a desired trim lever.
The default setting is that the Flap Trim is allocated to “FLAP TR”, and the Flaperon Trim is allocated to “FPRN”.
Once the lever is selected, it is possible to move the center position for operation.
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー
⿟ To prevent mistaken operation of the Camber Position (Trim Position) that has been set in each of the Flight
Modes, the sensitivity of the trim can be set to zero. After setting the number of steps of the FLAP and FPRM
Trim in the Trim System screen in the System List, these should be set to zero. By doing so, even though the Trim
lever will not actually operate, the set positions will remain memorized.
▋
▋
Caution▋Note
⿟ Actually operate the servos and carefully confirm the settings before flying.
Function▋List
Break Function(BREAK / BREAK BY ELEV STICK) Time Delay(DELAY) Offset Value (OFFSET)