JR ProPo XG11, Operation Manual

Page: 37 / 124

35
▋ Throttle▋hold【THRO▋HOLD】
▋ ▋ Function▋Explanation
This function is for autorotation landings – it holds the Throttle Servo at a low position. Using a
selected switch, the engine can be cut, or fixed at an optional slow position. Further, there is also
a Stick Auto function that allows switching of the servo to the Hold position when the stick is
lowered to a preset position.
▋
▋
Setting▋Method
This function is “INH” by default. Set the function to ACT. Then adjust the hold position as required. The Hold
switch is used by default, but this selection can be modified
▋ ▋ For▋Helicopter
By default, the “HOLD SW” is allocated to POS1. It is possible to allocate this switch to any desired switch
locations.
⿟ Stick Auto Function (STICK AUTO)
When “STICK AUTO” is set, the servo will change to the Hold position when the stick is lowered past a
predetermined position. To deactivate this function simply turn off the allocated switch.
Initially this function is inhibited. To activate this function, move the cursor to “INH”, and press the dial to “ACT”.
Move the cursor to the inversed display next to STICK AUTO, Move the throttle stick to desired position and press
the “STO” key to set the position (a numerical value between 0-100 will be displayed on the inversed display).
To “INH” this function, press the CLR key while the display is inversed.
⿟ Hold delay function (DELAY)
It is possible to set a “DELAY“ to prevent a sudden increase in engine rotations when the Hold switch is set to
OFF. The duration of the delay can be set between 0.1sec to 2.0sec.
If the Hold Delay is set, any throttle setting in the Servo Speed function will be cancelled.
⿟ By setting throttle hold active, this function acts like an additional flight mode. It is possible to set dedicated Dual
rates, Pitch Curve, etc to this function.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
In order to use the function,
INH should be changed to ACT.
Operation condition
Stick Auto function Stick Auto function
Hold Delay function Hold Delay function
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー